Half Moon Switch ???
-
- Posts: 28
- Joined: 10 Jul 2018, 08:21
- 6
- Your Nord Gear #1: Nord Electro 5
- Has thanked: 2 times
- Been thanked: 3 times
Half Moon Switch ???
Hi, I'm new here. My name is Lucky.
I recently purchased Nord 5D73 & a Half Moon Switch. I'm trying to use the Menu to set the Half Moon Switch but can't find Rotary Control in the menu Settings? I'm holding Shift & turning Menu Dial & it scrolls thru all the Keyboard instruments?
What am I missing?
Thanks,
Lucky
I recently purchased Nord 5D73 & a Half Moon Switch. I'm trying to use the Menu to set the Half Moon Switch but can't find Rotary Control in the menu Settings? I'm holding Shift & turning Menu Dial & it scrolls thru all the Keyboard instruments?
What am I missing?
Thanks,
Lucky
-
- Posts: 1721
- Joined: 14 Jul 2017, 11:32
- 7
- Your Nord Gear #1: Nord Electro 6
- Your Nord Gear #2: Nord Stage 3
- Has thanked: 703 times
- Been thanked: 744 times
Re: Half Moon Switch ???
If you didn't get the manual, you can download it from Nords homepage here: http://www.nordkeyboards.com/sites/defa ... on%20E.pdf
On page 10 it says: "Menus are browsed with the MENU dial, and values are changed with the same dial while pressing SHIFT."
On page 10 it says: "Menus are browsed with the MENU dial, and values are changed with the same dial while pressing SHIFT."
-
- Posts: 28
- Joined: 10 Jul 2018, 08:21
- 6
- Your Nord Gear #1: Nord Electro 5
- Has thanked: 2 times
- Been thanked: 3 times
Re: Half Moon Switch ???
That's what I'm doing but I'm not seeing anything except instruments? Piano, Organ & Synth variations. Not seeing a mode for Half Moon Switch On, Off etc.
Any ideas?
Thanks,
Lucky
Any ideas?
Thanks,
Lucky
-
- Posts: 1721
- Joined: 14 Jul 2017, 11:32
- 7
- Your Nord Gear #1: Nord Electro 6
- Your Nord Gear #2: Nord Stage 3
- Has thanked: 703 times
- Been thanked: 744 times
Re: Half Moon Switch ???
Did you activate the system menu first (i.e. press shift and the A button at the same time)? Whatever is below the buttons or dials are the functions activated by holding down shift when you press/dial.
-
- Posts: 28
- Joined: 10 Jul 2018, 08:21
- 6
- Your Nord Gear #1: Nord Electro 5
- Has thanked: 2 times
- Been thanked: 3 times
Re: Half Moon Switch ???
I've got the Rotary Control Type set to Half Moon & I don't hear any difference when switching Half Moon Switch fast or slow? Any suggestions?
Thanks,
Lucky
Thanks,
Lucky
Last edited by Lucky on 11 Jul 2018, 08:05, edited 1 time in total.
-
- Posts: 1721
- Joined: 14 Jul 2017, 11:32
- 7
- Your Nord Gear #1: Nord Electro 6
- Your Nord Gear #2: Nord Stage 3
- Has thanked: 703 times
- Been thanked: 744 times
Re: Half Moon Switch ???
For some of the pedals, the current state is shown in the same menu (i.e. the one where you changed to half moon switch). I don't know if that is also the case for this menu, but you could check to see if the state is shown and if you can see a change when you manipulate the switch.
And then just checking: Are you playing an organ program that has the rotary switched on (there are some organs where the rotary is not switched on)? Does the speed change (the LEDs light up to indicate so too) if you press the fast/slow (or stop) buttons on the board it self, and can you hear a difference? And do the LEDs change when you manipulate the half moon?
And then just checking: Are you playing an organ program that has the rotary switched on (there are some organs where the rotary is not switched on)? Does the speed change (the LEDs light up to indicate so too) if you press the fast/slow (or stop) buttons on the board it self, and can you hear a difference? And do the LEDs change when you manipulate the half moon?
-
- Posts: 28
- Joined: 10 Jul 2018, 08:21
- 6
- Your Nord Gear #1: Nord Electro 5
- Has thanked: 2 times
- Been thanked: 3 times
Re: Half Moon Switch ???
I called Sweetwater Tech Support & they determined there's a problem with the Cord in the Hal Moon Switch. They're sending me a new one. Should have it in a few days.. I'll let you all know.
Thanks,
Lucky
Thanks,
Lucky
-
- Posts: 28
- Joined: 10 Jul 2018, 08:21
- 6
- Your Nord Gear #1: Nord Electro 5
- Has thanked: 2 times
- Been thanked: 3 times
Re: Half Moon Switch ???
I got the new Replacement Nord Half Moon Switch, attached it, plugged in the Cable, menu set to Half Moon & still nothing?
Can I control it using the Switch? Does it need to be operated from a Foot Pedal? Or?
Am I missing something? Could it be the Keyboard? I bought it new & it doesn't get played much.
I appreciate any & all feedback.
Thanks,
Lucky
Can I control it using the Switch? Does it need to be operated from a Foot Pedal? Or?
Am I missing something? Could it be the Keyboard? I bought it new & it doesn't get played much.
I appreciate any & all feedback.
Thanks,
Lucky
Last edited by Lucky on 14 Jul 2018, 08:56, edited 1 time in total.
- Quai34
- Posts: 1876
- Joined: 01 Jan 2012, 23:02
- 12
- Your Nord Gear #1: Nord Stage 2
- Your Nord Gear #2: Nord Lead 1/2/2x
- Location: CANADA WINNIPEG
- Has thanked: 117 times
- Been thanked: 309 times
- Contact:
Re: Half Moon Switch ???
That's weird, I never had any issues with it, I bought it when it was still affordable, like 150$...Don't you have a store close by that you could check it with?
Stage 2/C2/NL2X+TC Pedals, 2XMatrix, EMU P2K, TX802, DSI P8/Tetra+H9, P12+TC HoF, D50+PG1000, XV5080,AX keytar, Streichfett, Drumbrute.Ibanez SR1200 & 2605 basses, Artstar AS153,G&L L2000,Legacy HSS,Asat Blueboys,Asat Deluxe Savanna.genelec 8040A.