Hello,
Could anyone help? I've recently picked up a G1 and am running it with stage-editor. I managed to track down a copy of the Wizoo book and accompanying example patches. However, I can't seem to open the example patches. I keep receiving a message saying 'can't load file. File format is not a known Modular file'. Could anyone advise? They are .pch files.
Thanks in advance
Can't Load File G1
-
Mr. Marko
- Posts: 196
- Joined: 08 Mar 2009, 19:15
- 15
- Your Nord Gear #1: Nord Stage 4
- Your Nord Gear #2: Nord Modular
- Has thanked: 9 times
- Been thanked: 47 times
Re: Can't Load File G1
the only software that works with G1 can be downloaded here:
https://www.nordkeyboards.com/downloads/nord-modular
the G1 is MIDI ONLY...PC In / PC Out jacks get connected to a MIDI Interface and assigned in the editor software.
https://www.nordkeyboards.com/downloads/nord-modular
the G1 is MIDI ONLY...PC In / PC Out jacks get connected to a MIDI Interface and assigned in the editor software.
NS4 / NS3 / NS-EX / Modular G1 / G2 / G2X / NL3
Basically Too Many Nords to Haul to a Gig
Basically Too Many Nords to Haul to a Gig
Re: Can't Load File G1
Hello,
Sorry, I didn't realise anyone had replied to this. It turns out the files were broken and needed to be repaired.
Sorry, I didn't realise anyone had replied to this. It turns out the files were broken and needed to be repaired.
Loading Files to Editor G1
Hello,
Can anyone help? I'm running the stage engine encapsulation of the G1 editor on a Mac. The program runs fine most of the time but I'm having a problem if I load a new model to a slot and move between slots. The editor display breaks up. I've been in touch with stage engine and made a couple of amendments to the encapsulation, but the problem persists. Is this a problem with other ways of running the editor. The problem I have with Byte Order is that it crashes.
Thank you
Can anyone help? I'm running the stage engine encapsulation of the G1 editor on a Mac. The program runs fine most of the time but I'm having a problem if I load a new model to a slot and move between slots. The editor display breaks up. I've been in touch with stage engine and made a couple of amendments to the encapsulation, but the problem persists. Is this a problem with other ways of running the editor. The problem I have with Byte Order is that it crashes.
Thank you