Nordstage 3 outputs

[jerrychopin]

Hi guys.. i have a nordstage 3..in the back i have the outputs..
My question is. I use onstage l & r..so output 1 and 2..
But can i use also in combination with 1 and 2..those outputs to use this like a monitor? So 1 and to 2 goes to the PA mix.. and 3 and 4 i wanne use it like a monitor nearby me.. possible??? Thx

[Schorsch]

Hi,

die you check the manual? Pages 53+54 of the English manual are your friends

[jerrychopin]

Yes.. i just find the output for one panel example.. but i need everything whats come out of 1 and 2.. also out 3 and 4

[Schorsch]

You just have to set the output routing mode to “global” (not “program”) and then in MAIN the output for both Panel A and Panel B to 1-4, and SUB to “off”

Please note that sounds from those engines which have the rotary effect enables go through 1-2, not sure if these go to 3-4 as well when the output is set to 1-4!