Nord User Forum

Suggestions for a patch to use on my Nord Stage 3? Looking for an ARP Odyssey Sample that I can add delay to? Thx!

No sample needed. The original is probably a minimoog anyway.

Set the synth to classic square wave, adjust filter to no or low resonance, set filter envelope/LFO mod to zero, adjust the cutoff until it sounds right, and add delay with feedback on maximum and the wet/dry mix at 50%. .

For the delay, I’d put it into bandpass mode to get it closer to the original tape echo than the Stage 2 was capable.

Fantastic - I just learned a whole lot on how to make my own patches from this set of instructions. Thank you so much!