Hello everyone,
I discovered something strange when assigning the Modulation Wheel to the Rotary Speed of an organ.
When this is turned up, the speed of rotation increases, when it is turned to zero, the sound becomes very different than what you do with the SLOW/FAST button.
The sound of the organ is getting bad because of this.
So I can't use the wheel to control the rotary speed.
Anyone with the same experiences?
Problem assigning Wheel to Organ Rotary speed control
-
mzonneveld
- Posts: 5
- Joined: 20 Mar 2017, 22:28
- 8
- Your Nord Gear #1: Nord Stage 3
- Has thanked: 5 times
- Been thanked: 1 time
- Contact:
-
maxpiano
- Patch Creator
- Posts: 6844
- Joined: 27 Jun 2011, 13:29
- 13
- Your Nord Gear #1: Nord Stage 3
- Location: Italy
- Has thanked: 505 times
- Been thanked: 2398 times
Re: Problem assigning Wheel to Organ Rotary speed control
Nothing strange, MW controls the Rotary speed directly and continuously (see NS3 Manual edition N, pag. 49 )
• the Rotary speed can be continuously controlled with a Morph source, in which case the MORPH LED will be lit. This makes it possible to set the rotary at speeds other than just fast, slow and stopped.
so at 0 the Rotary is in Stop and the sound depends on the (random = different every time) position of horn and bass (simulated) speakers at the time of Stop.
• the Rotary speed can be continuously controlled with a Morph source, in which case the MORPH LED will be lit. This makes it possible to set the rotary at speeds other than just fast, slow and stopped.
so at 0 the Rotary is in Stop and the sound depends on the (random = different every time) position of horn and bass (simulated) speakers at the time of Stop.